Before You Start
Use and care of the remote
Installing the battery
Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus (–) poles pointing in the proper di-
! When using for the first time, pull out the
film protruding from the tray.
Keep the battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
! Use only one CR2025 (3 V) lithium battery.
! Remove the battery if the remote control is not
used for a month or longer.
! Danger of explosion if battery is incorrectly re-
placed. Replace only with the same or equiva-
! Do not handle the battery with metallic tools.
! Do not store the battery with metallic materi-
! In the event of battery leakage, wipe the re-
mote control completely clean and install a
! When disposing of used batteries, please
comply with governmental regulations or en-
vironmental public institutions' rules that
apply in your country/area.
Using the remote control
Point the remote control in the direction of the
front panel to operate.
! The remote control may not function prop-
erly in direct sunlight.
! Do not store the remote control in high tem-
peratures or direct sunlight.
! Do not let the remote control fall onto the
floor, where it may become jammed under the
brake or accelerator pedal.
Resetting the microprocessor
The microprocessor must be reset under the
! Prior to using this unit for the first time
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
Remove the front panel.
Refer to Removing the front panel on the pre-
Press RESET with a pen tip or other
Replace the front panel by clipping it