Assembly And Startup Procedure; Device Installation; Unpacking And Checking; Assembling The Media Modules - Hirschmann MICE MS20 User Manual

2

Assembly and startup procedure

The Industrial ETHERNET Modular Industrial Communication Equipment
(MICE) Family has been developed for practical application in a harsh indus-
trial environment. Accordingly, the installation process has been kept simple.
On delivery, the device is ready for operation.
The following procedure is appropriate for assembly:
D

Unpacking and checking

D

Assembling the media modules

D
Filling out and attaching the labels
D
Assembling the SFP modules
D
Adjusting the DIP switch settings on the basic module
D
Adjusting the DIP switch settings on the MICE MM3-2AUI media module
(if existent)
D
Connecting the terminal block for supply voltage and signal contact,
connecting the supply voltage
D
Assembling the terminal block, startup procedure
D
Assembling the device on the ISO/DIN rail, grounding
D
Connecting the data lines
D
Assembling the expansion module
2.1

Device installation

2.1.1 Unpacking and checking
V Check whether the package was delivered complete,
see "Scope of delivery" on page
V Check the individual parts for transport damage.
2.1.2 Assembling the media modules
On delivery, the device is ready for operation. Media modules can be assem-
bled and disassembled during running operation.
V To fasten a media module, first remove the protective cap over the plug.
V Plug the media module onto the plug.
V Tighten the 4 screws on the corners of the media module.
V Fit the media modules one after the other from the left to the right.
V Check whether the switch pre-setting suits your requirements.
MS20/MS30
Release 2.0 02/06
41.
21