Kenwood DNX8120 Instruction Manual page 123

Removing Monitor/Player Unit
b\
~
1. Remove the hard rubber frame by referring to the
removal procedure in the section <Removing the
Hard Rubber Frame>.
2. Remove the Hex-head screw with integral washer
(M4
x
8) on the back panel.
3. Insert the two removal tools
®
deeply into the
slots on each side, as shown .
Removing the Unit
--------
- - - ~ ~ ~ - ~
1. Engage the catch pins on the removal tool
®
and
remove the two locks on the lower level.
Lower the frame and pull it forward as shown in
the figure.
~ ~ccessory
®
. . !&
\.
~~
Removing the Hard Rubber Frame
(escutcheon)
• The frame can be removed from the top side in the same
manner.
2. When the lower level is removed, remove the
upper two locations.
l~~~
4. Lower the removal tool toward the bottom, and
pullout the unit halfway while pressing towards
the inside.
Q
Q
Be careful to avoid injury from the catch pins on the
removal tool.
5. Pull the unit all the way out with your hands, being
careful not to drop it.
English
I 11