Kenwood DNX8120 Instruction Manual page 116

Connection
If'
If you connect the ignition wire (red) and the battery
~
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire. Always
connect those wires to the power source running
through the fuse box.
Ignition key
switch
o-+;...;.;AC::..:;C_
A
B
A+-
Ignition wire (Red)
Car fuse box
Car fuse box
(Main fuse)
B+-
C+-
Battery wire (Yellow)
Ground wire (Black)
8
(To car chassis)
( 1:1
==+1
1)=
Antenna Cord FM/AM
antenna input
Parking sensor wire (Light Green)
Reveres sensor wire (PurplelWhite)
For the sake of safety, be sure to connect the parking sensor.
' - - - - - '
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
Q
Connect to the vehicle's parking brake
~ detection switch harness.
Steering remote control input (Light Blue/Yellow)
To steering remote
~F====~======~=~========
Q...
To use the steering wheel remote control feature, you need to an
~
exclusive remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
: _. Dimmer control wire (Orange/White)
To car light control switch
Connect to the terminal that is grounded when either : Mute wire (Brown)
the telephone rings or during conversation. =,=====================
Q
To connect the Kenwood navigation system,
~ consult your navigation manual.
Depending on what antenna you are using, : Motor antenna control wire (Blue)
connect either to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type antenna.
When using the optional power amplifier, : Power control wire (Blue/White)
connect to its power control terminal.
To "EXTAMPCONT" terminal of the amplifier: : External amplifier control wire (Pink/Black)
having the external amp control function. _
~
If no connections are made, do not let the cable come out from the tab.
4
I
DNX8120/DDX812/DDX8032BT