Miter Gauge Adjustment - Steel City 35903 User Manual

1. Make sure the switch is
power cord from power source.
2. Open motor cover and verify on the motor tag that
motor is dual voltage.
3. If motor tag states that it is dual voltage remove
junction box cover (A) on motor (B).
4. Using wiring diagram on inside of junction box
cover, reconnect motor leads for 240-volt or refer to
page 13 of wiring diagram.
5. Replace junction box cover and close motor cover.
. Replace the 120-volt plug with a plug rated for 240-
volt operation.
7. The ON/OFF switch is 4-pole and does not need
modified.

MITER GAUGE ADJUSTMENT

WARNING
!
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
Fig. 35
1. The miter gauge has adjustable positive stops at 0-
degree and 45-degrees or it can be manually set at
any angle between
2. To rotate miter gauge body (A), loosen knob (B) and
pull out plunger (C) and rotate miter gauge body to
desired angle and tighten knob.
3. To rotate to the next positive stop, pull plunger (C)
out, rotate miter gauge body then push plunger
back in and continue rotating miter gauge body until
it stops against next positive stop.
"OFF" and disconnect
SEE FIG 34.
0-degrees.
SEE FIG 35.
ADJUSTING POSITIVE STOPS
Fig. 36
1. To adjust 0-degree positive stops, loosen knob (B),
pull out on plunger (C) and turn miter gauge over.
2. Loosen the lock nut (D) 3 or 4 turns.
3. Place a square against the guide bar and front of the
miter gauge body. Square the miter gauge body to
the guide bar and tighten knob.
4. Push in plunger and make adjustments to stop screw
(E) so that it touches the plunger and tighten lock
nut.
5. Recheck the positive stop angle to the saw blade.
Insert the guide bar into the miter slot and slide the
miter gauge up to the saw blade.
. To check, place a square against the saw blade and
miter gauge body. If any more adjustments are
needed repeat steps above.
7. To set both 45-degree positive stops, repeat steps 1
thru above at the 45-degree settings.
Arbor gib assembly adjustment
A dovetail gib is provided on the arbor height
assembly to insure a good sliding fit between the
arbor assembly and the trunnion bracket when
raising and lowering the blade. This gib has been
adjusted at the factory and should not need any
further adjustment. If adjustment is necessary,
perform the following steps.
28
SEE FIG 36.