Wall Mounting Instructions - Cisco DPR2320 Installation And Operation Manual

Location and Dimensions of the Wall-Mounting Slots
The following illustration shows the location and dimensions of the wall-mounting
slots on the bottom of the modem. Use the information on this page as a guide for
mounting your modem to the wall.

Wall Mounting Instructions

Complete these steps to mount the modem to the wall.
1 Using a drill with a 3/16-in bit, drill two holes at the same height and 4 inches
apart.
2 Are you mounting the cable modem gateway into a drywall or concrete surface
where a wooden stud is not available?

If yes, drive the anchor bolts into the wall and then go to step 3.

If no, go to step 3.
3 Install the mounting screws into the wall or the anchor bolts, as appropriate, and
leave a gap of about 1/4-in. between the screw head and the wall.
4 Verify that no cables or wires are connected to the cable modem.
Lift the cable modem gateway into position. Slip the large end of both mounting
5
slots (located on the back of the modem) over the mounting screws, and then
slide the modem down until the narrow end of the keyhole slot contacts the shaft
of the screw.
Important: Verify that the mounting screws securely support the modem before
you release the unit.
68-4004214-01 Rev D
How Do I Mount the Cable Modem Gateway on the Wall?
19