Saving Your Configuration - Cisco DPR2320 Installation And Operation Manual

Chapter 3 Basic Configuration
Restarting the Cable Modem Gateway
Use the Setup Basic Settings - Restart Cable Modem page to restart your cable
modem gateway.
Click Restart Modem in the Basic Settings section of the Setup page to access the
Basic Settings - Restart Cable Modem page.
Click Reboot Cable Modem to restart the cable modem gateway.
Note: Restarting your cable modem gateway does not reset any of the settings.
Setup Basic Settings - Restart Cable Modem Page Example
The following illustration is an example of the Restart Cable Modem page.

Saving Your Configuration

Use the Setup Basic Settings - Save RG Configuration to Local PC page to save your
current cable modem gateway configuration to the hard drive on your PC or to a
floppy disk. You will then be able to restore the cable modem gateway
configuration, if necessary.
Note: If you are not familiar with the procedures detailed in this section, contact
your service provider before you attempt to change any of the cable modem gateway
default settings.
Click Save Configuration to your PC in the Basic Settings section of the Setup page
to access the Setup Basic Settings - Save RG Configuration to Local PC page.
46 68-4004214-01 Rev D