Cisco DPR2320 Installation And Operation Manual page 23

DPR2320 and EPR2320 Back Panel Components
The following illustration shows the description and function of the back panel
components of the DPR2320 and EPR2320 cable modem gateways.
Important: Do not connect your PC to both the Ethernet and USB ports at the same
time. Your Internet service may not function properly if both the Ethernet and USB
ports are connected to the same PC at the same time.
68-4004214-01 Rev D
1 ANTENNA—Provides a communication connection for the
built-in wireless access point (WAP) to allow wireless
devices to communicate with the cable modem gateway
2 POWER—Connects the cable modem gateway to the DC
output of the AC power adapter that is provided with your
cable modem gateway
CAUTION:
Avoid damage to your equipment. Only use the AC
power adapter that is provided with your cable
modem gateway.
RESET—Activating this switch resets the cable modem
3
gateway to factory default values and reboots the cable
modem gateway
Note: This switch is for maintenance purposes only. Do not
use unless directed to do so by your service provider.
ETHERNET—One RJ-45 Ethernet port (on DPR2320 and
4
EPR2320 modems) or four RJ-45 Ethernet ports (on
DPR2325 and EPR2325 modems) connect to the Ethernet
port on your PC or to an Ethernet hub or router on your
home network
5 USB—12 Mbps USB port connects to the USB port on your
PC
6 CABLE—F-connector connects to an active cable signal
from your service provider
Cable Modem Gateway Components
7