Advertisement
IG21, IG21R and IG31R Hardware Installation Guide
DIN Rail Mounting Instructions for IG21, IG21R and IG31R
DIN Rail Mounting Instructions for IG21, IG21R and IG31R
The DIN Rail Mounting Kit supports either a horizontal or vertical mounting of the IG21.
To attach the DIN Rail Bracket to the IG21, follow the steps noted below:
1.
Position the DIN Rail Bracket over the two mounting holes as shown in Figure 1.
2.
Attach the DIN Rail Bracket to the back of the IG21 using the two screws provided using a torque of 13-15 inch-pound.
The screw thread diameter is 3.0 mm, the screw head diameter is 5.5 mm, and the screw length is 7.0 mm.
Figure 1
DIN Rail Mounting Bracket on IG21 is shown in the illustration
Mounting Kit Contents
Adapter plate (1) [part number: pending]
DIN Rail Bracket (1) [part number: pending]
Screws
Note: All of the screws noted throughout this guide, will be shipped with the mounting kits.
Attaching the Adapter Plate for IG21R and IG31R
To attach the Adapter Plate to the IG21R or IG31R, follow the steps noted below:
1.
Position the Adapter Plate over the four mounting holes as shown in
2.
Attach the Adapter plate to the back of the IG21R or IG31R using the four screws provided using 13-15 inch-pound of torque. The
screw thread diameter is 4.0 mm, the screw head diameter is 8.0mm, and the screw length is 4.7 mm.
Figure
2.
4
Advertisement
