Cisco DPR2320 Installation And Operation Manual page 77

Setup Advanced Settings - IP Address Pass-through Page Description
The Setup Advanced Settings – IP Address Pass-through page allows you to bypass
NAT by adding MAC addresses for passthrough CPEs. You can also use this page to
remove MAC addresses for passthrough CPEs you have entered previously.
Function Keys
The following table describes the function keys associated with the Setup Advanced
Settings – IP Address Pass-through page.
Key
Add
Remove
Configuring Advanced Networking Features
Use the Setup Advanced Settings – Advanced Networking Features page to
configure RIP parameter related to authentication, destination IP address/subnet
mask, and reporting intervals. RIP automatically identifies and uses the best known
and quickest route to any given destination address. RIP announcements are only
active when a WAN IP address is statically assigned.
Note: If you are not familiar with the advanced settings detailed in this section,
contact your service provider before you attempt to change any of the wireless home
gateway defaults advanced networking settings.
Click Advanced Networking Features in the Advanced Settings section of the Setup
page to access the Setup Advanced Settings – Advanced Networking Features page.
68-4004214-01 Rev D
Description
Click to add a MAC address you have entered
Click to remove a MAC address you have previously entered
Configure Advanced Features
61