Vocal Processor (Vocal Harmonizer); Activation Of The Vocal Processor; Vocal Processor Edit; Preset - GEM WK2 Owner's Manual

VOCAL PROCESSOR (Vocal harmonizer)

If your WK2 has been installed with the optional Vocal Processor, you will have access
to a digital vocal harmonizer. If the Vocal Processor is not installed, when you press the
VOCAL P. button, the display will show the message "DISABLED".
After activating the Vocal Processor, it is possible to select the incorporated presets and
access various edit functions associated to the Vocal P. using the 4 PADS buttons.
The WK2 fitted with the Vocal Processor, is able to add vocal harmonies to your
voice automatically (up to 4 voices) with 16 bit resolution.
To control the level of the microphone signal at the input stage, refer to the para-
graph "Regulating the Mic/Line signal" outlined on page XX.

ACTIVATION OF THE VOCAL PROCESSOR

The Vocal Processor operates alternately to the SAMPLING function. If you wish to add
vocal harmonies to your voice, be sure that the instrument is not set for SAMPLING
operations.
1. Be sure that the VOCAL PROCESSOR module is correctly installed.
The small module must be inserted in the appropriate slot at the back of the panel.
2. Press the VOCAL P. button
The display shows an arrowhead next to the VOCAL P. inscription to indicate the
activation of the function.
3. Assign the track that you wish to associate to the Vocal Processor by pressing PAD 3 (Edit),
then using the +/– buttons of the right hand selection keypad to select the track.
It is best to use either of the keyboard tracks (Upper 1, Upper 2 or Lower), or in Song
mode, track 5.
4. Play and hold one or more notes on the keyboard and sing or speak into the microphone.
You will hear a harmonisation effect consisting of one or more voices that will de-
pend on the current Vocal P preset.
NOTE: To activate the Vocal P. after loading a Song or MIDI File, it is sufficient to press
the Vocal P button and sing into the microphone with the song in play. If the harmonised
effect cannot be heard, check that the song track associated to the Vocal P (usually
track 5) corresponds to the track set in the Edit section (pad 3 - track 05).

VOCAL PROCESSOR EDIT

It is possible to change Preset and edit some of the VOCAL PROCESSOR parameters
using the 4 PADS which have inscriptions that are valid when the Vocal P. function is
currently being used.

PRESET

Hold down the VOCAL P. button for a few seconds to display the current Preset as-
signed to the function.
Use the PAGE buttons to select a different Preset.
To memorise a preferred preset together with other associated settings (track number,
Vocal volume etc...), save the settings to any of the 63 available Performances (hold
Store Performance then press Enter).
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Sampling 79