Programmable Pads Assign; The Wk2 Pads - GEM WK2 Owner's Manual

Programmable Pads Assign

THE WK2 PADS

It is possible to assign the following to the 4 PADS:
- Samples.
- individual percussive sounds from the Drumkits.
The Pads assign procedure
1. Assign a DRUMKIT or a SAMPLE to one of the real time tracks (Upper 1 or UPPER 2).
You can programme the effect, volume, etc., using the track edit pages as already
explained.
2. Press and HOLD the PAD button to which you wish to assign a Sound.
3. While still holding the Pad, press the key on the keyboard corresponding to the Sound you
wish to associate to the PAD.
4. Repeat the procedure for other PADS.
The resulting configuration will remain
5. Hold down STORE PERFORMANCE then press ENTER to store the PADS configuration to the
current Performance.
It is important to remember that the PADS are also used in Vocal Processor proce-
dures, therefore, it is essential that the instrument is not currently set to Vocal Proc-
essor mode when you want to use the Pads to play the Sounds/Samples assigned
to them.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
78 Owner's Manual
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○
Note: If the 4 PADS have been configured with certain note
numbers of a Drumkit (e.g. C2, F4, D2, C6), when you make
a sound change with a Sample or a different Drumkit, the
note numbers remain those memorised in the Performance
until changed again.
○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
08
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○