Adjusting The Image; Insert Batteries; Turn On The System - Epson Home Cinema System Installation Manual

Adjusting the Image

Follow the steps in this section to adjust your system and make it ready for use.

Insert Batteries

Insert the included batteries into the remote controls for both the projector and the Ensemble HD system, as
shown below.
Note
The projector remote control is used only to make initial adjustments to the projector, but it should be saved in case it's
needed after installation.
Projector remote control
Insert 2 AA batteries:

Turn On the System

1 Remove the protective foam from the projector lens, if you haven't done so already.
2 Remove the projector lens cap.
3 Make sure the MAIN menu is displayed on the Ensemble HD remote control. If necessary, press the
button.
MAIN
4
Point the remote control at the screen and press the
down and the projector and AV controller turn on.
Note
Make sure the remote control remains pointed at the screen until the built-in macro finishes turning on all the
equipment. (You see the
The projector lamp takes up to 30 seconds to achieve full brightness.
MAIN
button
icon flash on the remote control screen.)
Ensemble HD remote control
Insert 4 AAA batteries:
MAIN
DVD
CABLE
SAT
HD
RADIO
1 OF 2
ON
button to turn on the system. The screen comes
ON
51
button