Tecnoware ERA LED 0.65 User Manual page 15

Risk of electric shock: do not remove the cover. The UPS contains internal parts that are
at a high Voltage and are potentially dangerous, capable of causing injury or death by
electric shock.
There are no internal parts in the UPS that are user serviceable. Any repair or
maintenance work must be performed exclusively by qualified technical personnel
authorized by TECNOWARE.
TECNOWARE declines any responsibility if this warning is disregarded.
Warning to the technical personnel authorized for service: since internal components
are connected to the batteries, they will remain powered, and therefore dangerous,
even after the UPS has been disconnected from AC power mains. Before any repair or
maintenance work, disconnect the batteries, by removing the positive cable (red colour)
from the positive pole of the battery.
ANOMALY POSSIBLE CAUSE
ON/OFF button
The UPS does not
Batteries are flat
turn on
Electronic board failure
Input mains power cable
is disconnected.
The UPS always Input mains fuse is burnt Replace the fuse with another of the same type.
function on
Black-out conditions /
Battery mode
surge/ Over-Voltage or
Low-Voltage
Electronic board failure
Battery is not fully
Battery Autonomy
charged.
is too short
Electronic board failure
"OVERLOAD" alarm "OVERLOAD" condition
"FAULT" alarm "FAULT" condition
The UPS Management
Software sends a
The UPS does not
communication error
communicate with
the Computer
The Software is not
correctly installed
If the described anomalies should continue despite the advised troubleshooting, or should they
UPS ERA LED 0.65 – 0.85 – 1.1
ACTION TO SOLVE
Press the ON/OFF button and check that is pushed.
Recharge the batteries for at least 4 hours.
Refer to Technical Service.
Check the input mains power cable.
Check the presence of the electrical mains.
Wait until the AC Input Line returns to normal conditions.
Refer to Technical Service.
Recharge the battery for at least 6 hours.
Refer to Technical Service.
Disconnect all devices that cause the overload condition.
Check if UPS is in OVERLOAD condition.
Refer to Technical Service.
Check that the USB (or RS232) cable is correctly connected
between the UPS and the Computer.
Install correctly the specific Software for your Computer's
Operative System.
manifest in any other form, please contact:
TECNOWARE SERVICE
www.tecnoware.com
13 User's manual