Travis Industries 21 TRV GreenSmart Owner's Manual page 17

Right Log Installation
The right log has two holes that accept the pins on the burner and rear log. When placed correctly there
will be a minimal gap between the two logs. Make sure the bottom is placed so no burner ports are
blocked and there is a gap to the back wall.
VIEW
FROM
ABOVE
Right Twig Installation
The right twig rests on the burner and leans against the indent on the right log. Install the twig as shown
below. The bottom of the twig is placed one inch to the right of the center screw on the burner.
© Travis Industries
Maintenance
4090403
NOTE: Make sure the right log
does not rest against the back
of the firebox (or liner). If it
does, it will block light from the
accent light, creating a large
shadow. You may need to re-
adjust the logs to insure a ¾"
gap from the back.
100-01209_000
17