How To Install The Units; Control Unit Fap-7001/Fap-7011 - Furuno NAVpilot-700 Installation Manual

1. HOW TO INSTALL THE UNITS

1.1

Control Unit FAP-7001/FAP-7011

• The Control Unit can be installed three ways:
• Surface mount (fixed from front panel or fixed from rear panel (FAP-7011 only))
• Desktop mount, and
• Flush mount (Optional kit required, instructions, supplied separately).
Select a mounting location for the Control Unit, keeping the following in mind.
• Select a location with good ventilation.
• Shock and vibration must be the least possible.
• Use the supplied display hard cover when the system is not in use.
• Do not install the display unit under "Plexiglas" or other type of shielding material. Plexi-
glas can trap heat and moisture or magnify sunlight energy onto the surface of the dis-
play.
• For maintenance and checking purposes, leave space at the sides and rear of the unit
and leave slack in cables. See the outline drawing for recommended maintenance
space.
• Observe the compass safe distances shown in the safety instructions on page i to pre-
vent interference to a magnetic compass.
Control Unit-FAP-7001 Control Unit FAP-7011
1-1