Furuno NAVpilot-700 Installation Manual page 14

1. INSTALLATION
• Make sure there are no objects near the vent.
• Leave enough space around the unit for maintenance and servicing. The recom-
mended maintenance space appears in the outline drawing at the back of this manual.
• Observe the compass safe distances shown in the safety instructions on page i to pre-
vent interference to a magnetic compass.
Install the unit as follows:
Tabletop: Fasten with four self-tapping screws.
Bulkhead: Screw in two self-tapping screws for the upper side. Leave approximately 5
mm of the screws exposed. Hang unit on screws and tighten screws. Screw in two self-
tapping screws for lower side and tighten.
φ
2- 5
(0.2")
(FIXING
HOLE)
EARTH
TERMINAL
230±1(9.06"±0.03")
VENT
#70(2.75")
1-6
CABLE INLET
255(10.0")
#70(2.75")
90(3.54")