6. Attach the hard cover to protect the LCD.
Self-tapping screw
(4x16, supplied)
Liner
1.2
Processor Unit FAP-7002
This unit can be installed on a desktop or on a bulkhead. Select a mounting location con-
sidering the following points:
• Install the unit away from direct sunlight and water splash.
• Select a location where temperature and humidity are moderate and stable.
• Consider the length of the cable connected between the Processor Unit and other
units.
• Install the unit where you can easily remove the cover and access controls and con-
nectors.
• For the installation on a bulkhead, make sure the mounting location is strong enough to
support the unit under the pitching and rolling normally found on the boat.
• To prevent interference, separate the processor unit and its cables at least one meter
from communications equipment, communications antennas and cables for communi-
cations equipment.
Pan head screw
(M3x12, supplied)
Bracket
1. INSTALLATION
Connecting plate
Knob
1-5