Surface Mount - Furuno NAVpilot-700 Installation Manual

1. INSTALLATION
1.1.1

Surface mount

There are two types of surface mounts: Fasten from front panel and fasten from rear panel
(FAP-7011 only).
How to fasten Control Unit from front panel (FAP-7001/FAP-7011)
1. Using the surface mount template at the back of this manual, open a mounting hole in
the installation site.
2. Detach the front panel together with the keypad assy. Attach the sponge (supplied) to
the rear of display unit.
3. Set the Control Unit to the mounting hole, and fasten the unit with four self-tapping
screws (3x20, supplied).
4. Attach the front panel and keypad assy. to the Control Unit.
Control Unit
FAP-7001
How to detach front panel
Procedure is similar for FAP-7001.
Remover
1. Set remover to notch on
upper side of unit.
2. Pull remover to raise panel
slightly.
3. Similarly use remover to
raise panel at lower side.
4. Detach panel with hands.
1-2
Front Panel
Keypad Assy.
Front Panel
Control Unit
FAP-7011
Mounting Mounting
Hole Hole
Sponge
Self-tapping Screw
(3x20, 4 pcs.)
Self-tapping screw
(3x20, 4 pcs.)
Keypad Assy.
Mounting Mounting
Hole Hole
Sponge