Furuno NAVpilot-700 Installation Manual page 48

3. INITIAL SETTINGS
Helm sensor test (for Accu-Steer FPS 12V (or 24V) drive)
The helm sensor test checks the connection between the processor unit and the
Accu-Steer FPS 12V (or 24V) drive. If your drive unit is different, go to section 3.6.
29.Go back to the [INSTALLATION] menu, select [HELM SENSOR TEST] then push the
knob.
30.Select [YES] then push the knob. The message "TURN HELM PORT OR STBD.
PUSH ANY KEY TO ABORT." appears. Turn the helm to port or starboard.
31.The message "TURN HELM To OPPOSITE. PUSH ANY KEY TO ABORT." Turn the
helm in the direction opposite that done in step 30.
If the connection is normal, the message "HELM SENSOR TEST COMPLETED. PUSH
ENTER TO CONTINUE." appears. For failure, "HELM SENSOR TEST FAILED. CHECK
THE SENSOR. PUSH ENTER TO CONTINUE." appears. In case of failure, check to see
if your drive is the SAFE HELM 12 V (or 24 V). Also, check that the helm sensor cable is
correctly connected to TB5.
3-12
HELM SENSOR TEST
UNIVERSAL INPUT1: - -
UNIVERSAL INPUT2: - -
20 10 5 5 10 20