Daewoo DWD-UD123X Service Manual page 36

2-3 Spin Sequence
1) Water discharge
1 It is done according to functional organization 3-5, water discharge sequence.
2) Balanced spin
1 Depending on the amount of water, 3 steps of unbalance checks are done. If the criteria is satisfied, then it
advances to the next stage, spin R.
2 Spin B refers to the unbalance detection area at 350 rpm. If the amount of unbalance exceeds the reference value,
then it turns back to the textile attachment region.
3 Press the pause button in the middle of spin B. It restarts at the textile unfolding region.
4 The stocking and the lingerie course omits the unbalance region of 350 rpm.
5 The hand cloth/stocking/lingerie course reduces the duration of spin B by one minute. In other courses, reduction is
two minutes.
3) R (Real) spins
1 After passing spin B, spin R continues until the entire spin operation is completed.
2 Depending on the selected spin operation, the target rpm can be varied.
3 During the standard and heavy spin operation, the unbalance value is measured to determine the final target rpm.
4 If drying is selected and medium spin is selected, then the strongest spin sequence is performed.
5 If acceleration during spins is stopped, the cycle continues at constant rpm and performs braking.
6 If you press the pause button during spins, braking will stop the motor.
4) Spins for the sports shoes
1 No spin B is performed.
2 Like the washing motor operation, it repeats on/off operation with an interval of 10 seconds for five minutes at 45
rpm.
3 To remove water, textile pulling is skipped and low temperature drying is done for 36 minutes.
4 When the cycle is completed, to clean the tub, one cycle of rinsing and medium spin is used.
5) Hand cloth spins
1 Spin B's duration is one minute.
2 The main spin time is 1 minute. The speed changes quickly from 350 rpm to 710rpm.
3 Textile pulling is skipped. When the cycle is completed, to clean the tub, one cycle of rinsing and medium spin is
used.
6) Stocking course spins
1 Spin B's duration is one minute.
2 Spin B reaches 160 rpm. (350rpm and ascending region omitted.)
3 The main spin's duration is 1 minute and the motor turns at 160 rpm.
4 To reduce damage to the stocking, textile pulling is omitted.
7) Lingerie spins
1 Spin B's duration is one minute.
2 Spin B reaches 160 rpm. (350rpm and ascending region omitted.)
3 The main spin's duration is two minutes and the motor turns at 200 rpm.
4 To reduce damage to the lingerie, textile pulling is omitted.
34