Control Part Function Specification - Daewoo DWD-UD123X Service Manual

5. Control Part Function Specification

1. Function Specification
1) Sequence chart
Division
Senising
P
Water Supply
r
e. Pre. Wash
W
a
Drain
s
Balancing Spin
h
Mid. Spin
Senising
Water Supply
W
a Washing 1
s (Heating)
h
i
n
g
Washing 2
Drain
Balancing Spin
Mid. Spin
Water Supply
Washing 1
Drain
R
Balancing Spin
i
n Mid. Spin
s Water Supply
e
WASHING 2
Drain
Balancing Spin
MID. SPIN
Water Supply
WASHING 3
Drain
S
Balancing Spin
p
i
Main Spin
n
Crease care
End
End
Remain Time Display
NOTE
1. The heavy stains washing course includes pre-washing in the basic cycle.
2. In the standard course, rinsing is done twice.
3. For the standard course at 40 degrees, the heating washing time includes
the first seven minutes without heating. The duration of washing 2 is 40
minutes which is 20 minutes longer.
4. Depending on the water temperature, the heating washing time is
changed.
5. In the standard course, if full capacity (LS480 or higher) is detected, then
additional one hour of cold water washing is added. The result is 2:47.
(For the domestic inspection in the future.)
Time Normal
Liquid DET. Power DET. Middle
20sec
2min
10min
8min
1min
2min
3min
20sec
2min
90min
80min
35min
27min
30min
25min
40min
25min
20min
15min
1min
2min
3min
2min
3min
1min
2min
3min
2min
3min
1min
2min
3min
2min
3min
1min
2min
7min
5min
3min
60sec
10sec
1:42
6. For the liquid DET + standard course, the default water temperature is
COLD.
7. For the powder DET + standard course, the default water temperature is
40 degrees.
8. For the standard course with COLD water, the total washing time with
liquid DET is 1:00 and it is 1:47 with powder DET.
9. The default setting for My Preferred Course is 40 degrees of water
temperature, rinsing three times and med spin. After that, you should
select your own setting.
26
Heavy stain Whites
small Middle
75min
32min
1:47 1:59 2:26
Memory
Middle
85min
2:36 1:36