Daewoo DWD-UD123X Service Manual page 35

3) Sinse Sequence
part
Level Water Temp. Rinse Time
height(mm)
Normal Cold
Whites Cold
Steam soak Cold
Heavy stain Cold
Cold
Baby care
Cold
Sports shoes
Cold
Delicate
Cold
rag
Cold
stocking
lingerie Cold
Blanket Cold
Tub clean Cold
1 The motor speed for the stocking course and the lingerie course are 35 rpm.
4) Drain
1 Befor Drainge Sequence, Water Temp is dropped by cold water supply.
2 After Drainage Sequence, Drain Motor is still ON.
5) Medium spins
1 In the medium spin cycle, the designated rpm is achieved for each course After performing pre-B and B spins
twenty times, if it fails to enter into drying R, then it skips to the next operation.
2 When washing is terminated, load sensing is done to detect the amount of water before performing the first
medium spins By changing the reference value for unbalance depending on the amount of water, the main spin
operation can be performed
3 The medium spin for the sports shoes does not perform balanced spins For three minutes, instead of the main
spins, the motor operates at 45 rpm (10 sec on, 10 sec off)
4 The stocking course omits the medium spins cycle.
Mid. Spin
Mid. Spin
r.p.m
3min 3min Medium
3min 3min Small
3min 3min Medium
3min 3min Medium
3min 3min Small
3min 3min Small
3min 3min Small
2min 1min Medium
2min X X
2min 1min Small
3min 3min Small
3min 3min Small
33
MOTOR On/OFF (sec)
rpm. Water supply rinse
45 r.p.m 5/15 10/5
45 r.p.m 5/15 10/5
45 r.p.m 5/15 10/5
45 r.p.m 5/15 10/5
45 r.p.m 5/15 10/5
45 r.p.m X 10/5
45 r.p.m X 2/20
45 r.p.m 5/15 10/5
35 r.p.m X
35 r.p.m X
45 r.p.m 5/15 10/5
45 r.p.m 5/15 10/5
1/5
1/5