Table of Contents
Advertisement
The hob can be set to the desired position by turning the control
knob through the adjustment range in an anti-clockwise direction.
Igniting The Burners
The hob is fitted with a flame failure
device. Flame failure devices
operate by shutting off the supply of
gas to the burner in the event that the
flame is extinguished accidentally.
To ignite the burners, follow these instructions:
1. Lightly press the control knob down and turn the knob
anticlockwise to the maximum position. Firmly press and hold down
the control knob to begin the ignition process (a clicking sound
will be heard). Hold down the control knob for a few seconds after
ignition to allow the safety device to detect that the burner is lit.
2. Once the burner is lit, adjust the burner power to the required
position.
Please note:
•
The ignition device should not be operated for more than 15
seconds.
•
If a burner does not ignite, or turns off accidentally, turn the control
knob to the 'off' position, and wait for one minute before attempting
to reignite the burner.
•
If the burner does not ignite, repeat the ignition process with the
burner at the minimum position.
Fig.3
9
Advertisement
Table of Contents
