Operating Instructions; Glass Information; Glass Cleaning; Log Installation - Majestic fireplaces NVSTR36 Installation And Operating Manual

Glass Information

Only glass approved for use in Majestic
Fireplaces products may be used for re-
placement.
•
Glass doors are optional. The appliance may be
operated safely without glass doors.
•
The use of any non-approved replacement glass will
void all product warranties.
•
Bi-fold glass doors MUST BE completely open or
closed while the appliance is in operation.
•
Care must be taken to avoid breakage of the glass.
•
Under no circumstances should this appliance be
operated with broken glass. Replacement of the
glass as supplied by the manufacturer should be
completed by a licensed qualified service person.
•
Replacement glass is available through your
Majestic Fireplaces dealer and should only be
installed by a licensed qualified service person.

Log Installation

1. Open glass door (if installed).
2. Remove logs from the packaging.
As with all plastic
items, these logs
are not toys and
should be kept
away from children
and infants.
3. Place rear log on back
bracket. Ensure that log is
firmly positioned and there
is no side-to-side move-
ment.
4. Place the front log on the
front bracket. Ensure that
the log is firmly positioned
and there is no side to side movement.
5. Place the four top logs onto the front and rear logs
as shown in Figure 13. Ensure that the logs are se-
cure on the tabs located on the front and rear logs.

Ember Material Placement

Separate the ember material into small pieces—roughly
1/2" (13 mm) diameter—and place on the bracket over
the lower burner tubes. Do not pack down ember mate-
rial; leave in loose, fluffy condition for the most realistic
ember effect. (Fig. 14)
7412958

Operating Instructions

Fig. 13 NVSTR36/ NVCVR36 log placement.

Glass Cleaning

It will be necessary to clean the glass periodically.
During start-up, condensation, which is normal, forms
on the inside of the glass and causes lint, dust and
other airborne particles to cling to the glass surface.
Also, initial paint curing may deposit a slight film on
the glass. It is therefore recommended that the glass
be cleaned two or three times with a non-ammonia
household cleaner and warm water (we recommend
gas fireplace glass cleaner). After that the glass should
be cleaned two or three times during each heating
season depending on the circumstances present.
Clean glass after first two weeks of
operation.

Lava Rock

The lava rock provided with this fireplace must be
placed on the firebox base on either side of the burner
assembly. Do not place lava rock in combustion pan.
Under no circumstances should lava rock
be placed on any part of the burner assem-
bly.

First Firing

Upon completing the gas line connection, a small
20005477_log_placement
amount of air will be trapped in the line. When first light-
NVSTR_CVR36
ing the unit with pilot light, it will take a few minutes to
purge the trapped air.
9-23-02 rjs
Once purging is complete, the pilot and burner will light
and operate as indicated in the instruction manual.
Subsequent lightings of the appliance will not require
purging.
When lit for the first time, the appliance will emit a slight
odor for an hour or two. This is due to paint and lubri-
cants used in the manufacturing process.
After each lighting, vapor may condense and fog the
glass; this moisture disappears in a few minutes of
burning.
NVSTR/ NVCVR Series
LG312
11