Fueling; Starting - BLADEZ MOBY XS PB-SE823 Product Handbook

Fueling

This is a two-stroke engine. Only run the engine using a mixture of gasoline
and 2-cycle engine oil.
PLEASE READ OPERATING PROCEDURES BEFORE FUELING!
1. Mix fuel (minimum 90 octane) and 2-cycle engine oil in a separate container. Use
high quality 50:1 2-cycle oil. 2.6 oz of oil for every gallon of High-Octane Gasoline.
Make sure the fuel is well mixed by shaking the container.
2. Make sure that the engine is off!
3. Slowly open the GAS CAP, so that possible over-pressure disappears.
4. Clean the tank cap area to make sure that it is free from excess dirt and debris.
* Make sure that no dirt falls into the gas tank.
5. Pour pre-mixed Gas/Oil mixture into the GAS TANK. * Do not overfill.
6. After fueling, replace the GAS CAP and tighten.
Bladez Corp. • 20155 Ellipse • Foothill Ranch, CA 92610 • (866) 325-2339 • www.ebladez.com

Starting

Move at least 10 feet away from where
you fill up with gas.
1. Depress clear, plastic primer bulb (on
carburetor), several times briskly until it
fills with fuel.
2. Set the CHOKE LEVER to the CHOKED
(UP) position. (Fig. 5)
3. Pull the RECOIL STARTER briskly,
making sure to hold the handle in your
grasp. (Fig. 6) * Note: Do not allow it to
snap back, let it back slowly. You may
want to give it a little throttle by gently
squeezing the GAS LEVER.
4. It may be necessary to repeat step 3
several times until the motor starts.
When starting the MOBY XS for the first
time, it may be necessary to pull the
starter handle multiple times until it
starts.
*This is because the gas needs to be drawn
into the carburetor.
5. Once the engine has started, quickly
move the CHOKE LEVER into the RUN
(DOWN) position. (Fig. 5)
6. After the engine is started, let it warm up
for 2-3 minutes before riding.
Page 8