Tires And Wheels; Chain Adjustment - BLADEZ MOBY XS PB-SE823 Product Handbook

WARNING!
When the engine is idling, under no circumstances should your MOBY
XS be moving.
If the MOBY XS continues to move after idle speed adjustment, contact
Bladez or your local Bladez service center.

Tires And Wheels

The Bladez MOBY XS uses an identical rim and tire assembly on the front and rear
wheel, which means that the tires can be rotated. The wheels are actually two wheel
halves (split rim) bolted together to make it easier to remove and replace the tire and
tube.
Tire wear will differ based on rider weight, riding conditions and care. Replacement
tires can be obtained at your local Bladez dealer, through motorcycle shops, or from
the Bladez website at www.ebladez.com.
Tire Pressure
The tire must be inflated to a maximum of 60 P.S.I. It is also recommended to
use a tube additive like Slime available from any motorcycle shop, to avoid
inconvenient punctures.
WARNING!
Empty all air from the tire, prior to loosening the bolt to split the rim.

Chain Adjustment

The chain will come adjusted from the factory. However, it may be necessary to
adjust the chain from time to time.
How Tight Should The Chain Be?
If the chain is skipping or jumping on the sprocket teeth, it is too loose and
should be adjusted.
The chain should be tight enough not to skip, but have a little bit of play.
Bladez Corp. • 20155 Ellipse • Foothill Ranch, CA 92610 • (866) 325-2339 • www.ebladez.com
Adjusting The Chain
1. Loosen the rear axle bolt but do not
remove the axle.
2. Tighten or loosen the rear axle tension
screws until you find the proper chain
tension. (Fig. 11) (About 1/8 of an inch
of play will be the proper tension for your
chain)
Page 12