Maintenance; Recommended Tools; Carburator Adjustment; Idle Speed Adjustment - BLADEZ MOBY XS PB-SE823 Product Handbook

MAINTENANCE

Recommended Tools

To adjust and service the Bladez MOBY XS Power Board you will need the following
tools:
Allen Wrenches:
Wrenches:
Short reach Spark Plug Socket
Large Adjustable Crescent Wrench
Spark Plug Sockets
Philips Head Screwdrivers
Oil, Grease or Lubricant (such as WD-40)
Carburetor Adjustment
WARNING!
Never start the engine without the complete clutch cover assembled!
Otherwise the clutch can come loose and cause personal injuries.
In the carburetor, fuel is mixed with air. When the engine is test run at
the factory, the carburetor is basically adjusted. A further adjustment
may be required from time to time, depending on climate and altitude.
The carburetor has only one possible adjustment:
T= idle speed adjustment screw

Idle Speed Adjustment

When the idle speed is adjusted properly, the engine will run smoothly,
without pressing the THROTTLE LEVER. (Fig. 10)
Bladez Corp. • 20155 Ellipse • Foothill Ranch, CA 92610 • (866) 325-2339 • www.ebladez.com
3 / 4 / 5 / 6 mm.
10 / 13 / 16 mm open and ring combination.
If Adjustment Is Required:
1. Start the engine.
2. Using a long, Philips head screwdriver
gently close (clockwise) the T-screw
until the MOBY XS starts to move
forward.
3. Then open (counter-clockwise) the
screw until the MOBY XS stops.
4. You have reached the correct idle speed
when the engine runs smoothly below
the RPM when the MOBY XS starts to
move.
Note: Standard idle RPM is about 2500-
3000 RPM.
Page 11