Escea ST900 User Manual
Hide thumbs
Also See for ST900:
- Installation manual (49 pages) ,
- User manual (18 pages) ,
- Manual (9 pages)
Subscribe to Our Youtube Channel
Related Manuals for Escea ST900
Summary of Contents for Escea ST900
- Page 1 GAS FIREPLACE USER GUIDE ST900 NORTH AMERICA Ce manual est disponsible en Fran ais sur demande ç www.escea.net 630169_3_Manual_User_ST900_US_R-emotion...
- Page 2 To access this, the fascia must be removed. Escea recommends the ST900 is inspected and serviced by a licenced or qualified service person once every twelve (12) months.
-
Page 3: Table Of Contents
Normal operating Sounds and Smells > Warranty Information The ST900 electronic control system is designed to work within the temperature range of 0°C to 70°C, with a humidity level that is non condensing. This is to ensure safe operation of the electronic and gas control system. -
Page 4: Turning The St900 On
Basic Operation The ST900 remote control allows you to turn ON and OFF the fire, control the flame height in the Manual mode, or control the room temperature in the Thermostat mode. The remote has a maximum range of 10 meters, and... -
Page 5: Setting The Control Mode
Basic Operation Switching off the ST900 To turn off the fire, push the OFF button, to shut down the gas flow to the fire and switch it off. The OFF display will now appear in the display. Setting the control mode for the fireplace: There are three different modes for controlling the appliance: >... -
Page 6: Basic Operation
Basic Operation Automatic mode: If Auto is pressed in the initial screen, 25ºC (77 º F) appears as the desired temperature in the selected ↓ ↑ setting. In the bottom row, appear, indicating that we can change the desired temperature value by just pressing the left or middle button. - Page 7 Basic Operation Program mode (continued) The daily program screen consists of: A: Selected (including “Daily”). The selected day can be changed by pressing Change (middle button). B: Day schedule graphic. This bar displays the program for the whole day by showing the temperature setting for each hour of the day.
-
Page 8: Locking The Remote Control
To turn on the ST900, push the ON/OFF button on the touch pad. The system will emit a beep and begin the ignition process, which can take about 20 seconds. Once the start up process is complete, the pilot flame is lit. The ST900 is now in the 'Manual' mode and ready to be used. -
Page 9: Clearances
TV location decisions rest solely with the householder and the manufacturer / distributor will not be held liable for any adverse affects on a TV located near to the ST900 fireplace that may be caused by heat. The drawings below are suggestions that may be used as a GUIDE for those consumers who do decide to locate their TV above an ST900 gas fire. -
Page 10: Replacing Batteries
COMBUSTIBLE materials, then the below shows the maximum allowable size clearances to mantles or protruding for mantles or protruding surfaces surfaces mounted above an ST900 mounted above an ST900 be as shown by the shaded area in the diagram below... -
Page 11: Cleaning And Maintenance
Fascia Ensure the fascia is allowed to cool before handling. The ST900 fascia attaches to the fire by four hooks. To remove the fascia, simply lift it upwards 15-20mm, and pull towards you. Care should always be taken when handling the fascia. - Page 12 Do not operate the appliance if the glass has been broken, damaged, or the glass is not properly positioned/hooked onto the appliance. Cleaning your ST900 The unit must be cold before starting any form of maintenance or cleaning. The glass can be cleaned using standard window cleaner. If you wish the clean the inside of the glass, you can remove the glass assembly by following the instructions on page 8.
-
Page 13: Normal Operating Sounds And Smells
Sounds and Smells Note: Each time the fire is lit from cold the glass will fog up with condensation. This is normal and the condensation will disappear within a few minutes once the glass heats up. Sounds It is possible that you will hear some sounds from your gas appliance. This is perfectly normal due to the fact that there various types of materials used within your appliance. -
Page 14: Warranty Information
ESCEA, (documented in the Dealer Manual), and the product is operated and maintained in accordance with ESCEA operating and maintenance instructions, then for the first period of twelve (12) months from the date of purchase ESCEA will pay to the dealer who sold the appliance, a pre-determined sum to repair or replace any part of the Product that is deemed by ESCEA to be faulty. - Page 15 Except as provided herein, Escea is not responsible for direct, special, incidental or consequential loss or damages resulting from any breach of warranty or condition,...
- Page 16 Warranty following: use; revenue; actual or anticipated profits (including loss of profits on contracts); use of money; anticipated savings; business; opportunity; goodwill; reputation; any or indirect or consequential loss or damage howsoever caused including the replacement or equipment and property. Some states in Canada and in some States in the United States do not allow the exclusion of incidental or consequential damages, so the above limitation may not apply to buyer.
Need help?
Do you have a question about the ST900 and is the answer not in the manual?
Questions and answers