Charging Instructions; Tips For Extending Battery Life - BLADEZ PB-SM804SA Product Handbook

Charging Instructions

Tips For Extending Battery Life

1. You MUST charge completely prior to initial use. Charge completely before
storage, and approximately every 30 days if not in use.
2. Charge immediately after every use.
3. DO NOT allow your unit to discharge completely if possible. Recharging when
batteries are still at partial capacity helps to extend battery life.
4. For safety purposes, DO NOT charge for over 24 hours.
5. Turn the unit OFF when not in use.
1. Carefully remove the Power Board from the box.
2. Make sure the unit is turned OFF, (If equipped with
on/off switch).
3. Open the charging plug by rotating the safety cover
counter clockwise (Fig. 1).
4. Locate the AC CHARGER and plug it into wall. Insert
the charger (the end with the 3 prongs inside of it)
into the charging plug. A red light will come on the
Charger (Fig. 2). Your Power Board is now charging.
5. When the charge is complete, the light on the
Charger will turn GREEN, your Bladez Power Board
is now fully charged!
Note: If the light turns green right away, this is because the
unit was charged at the factory. Please continue charging for
6-8 hours prior to initial use.
6. Remove the charger from the charger plug and close
the safety cap.
IMPORTANT
Page 9