Replacing Extensions - Canyon SPeedMax CF Instructions Manual

Table of Contents

Advertisement

38
AdjUSTING ThE CANYON SPEEdMAx CF TO ThE RIdER
The armrests can be mounted lengthways in
four different positions and sideways in three
different positions.
Place the reinforcing plate underneath the
armrest.
Apply a little locking paste (medium strength)
to the threads of the relevant clamping bolts
and tighten them up to the prescribed tight-
ening torque of 5 Nm.
Make sure that the armrests are correctly and
firmly fixed.
Make a test ride to check the seating position.
Only glue the foam padding onto the armrests
once you are sure that you have found the
right position for the extensions and arm-
rests.
The shape of the spacers is de-
i
signed around the basic handle-
bars. Ensure that the spacers are aligned
correctly.
Ensure that you only clamp the L-
bend extensions within the marked
area ("End of clamping area").
AdjUSTING ThE CANYON SPEEdMAx CF TO ThE RIdER

REPLACING EXTENSIONS

If you wish to swap the extensions for another
model, you must first of all undo the cable
plug of the shifter cable that runs through the
extensions. Only then can you unscrew the
installed extensions.
Now hold the unscrewed extensions firmly at
the rear and pull off the extension clamping
piece in the direction of the cable.
If you wish to replace the standard extensions
with another version, the shift levers must be
removed and installed again afterwards. Note
the corresponding information in the operat-
ing instructions of the gear manufacturer.
Three different versions of exten-
i
sions are available. You can choose
between L-bend, S-bend and straight ver-
sions.
39
Take the new extension in your hand and guide
the cable into the extension and through the
opening to the outside. If necessary, use a
loop (e.g. made from a cable binder) to make
it easier to thread the cable through the open-
ing.
Now push the extension clamping piece back
on and mount the extensions on the handle-
bars.
You can find further information in the chap-
ter "Adjusting extensions and armrests".

Advertisement

Table of Contents
loading

Table of Contents