Canyon SPeedMax CF Instructions Manual page 11

18 ASSEMBLY FROM ThE BIKEGUARd
Screw each pedal manually into the thread of
its crank by two to three full turns. Continue
by using a pedal spanner to tighten the pedals
firmly.
Some types of pedal have to be tightened with
an Allen key.
Check the reliable fit of the pedals
after about 100 km (60 miles). The
pedals can come loose, and this can de-
stroy the thread and throw the rider off his
bike. Also check the reliable fit of the other
bolts according to the prescribed tighten-
ing torques.
Fix the white reflector to the handlebars and
the red reflector to the seat post as well as the
spoke reflectors to the spokes.
Read up on the road traffic regula-
tions in the country where you use
the road bike.
Di2 RECHARGEABLE BATTERY AND CHARGER
The di2 rechargeable battery of the Canyon
Speedmax CF is located at the lower end of
the seat post.
The seat post rechargeable battery is charged
by means of a USB connection at the handle-
bar distributor.
Only charge the rechargeable bat-
tery with the battery charger that is
supplied. do not use any other battery
charger from any other maker, even if the
plugs of the battery charger fit into your
rechargeable battery.
You can find further information
i
in the chapter "Shimano Di2" in
your bicycle manual road bike or at www.
shimano.com
ASSEMBLY FROM ThE BIKEGUARd
CHECKING AND ADJUSTING
Check the proper functioning of the gears.
Shift through all the gears. Make sure that
the rear derailleur does not collide with the
spokes when the chain runs on the largest
sprocket.
Read up on how to adjust the gears in the
chapter "The gears" in your bicycle manual
road bike.
After the wheel mounting do a brake
test when stationary. Actuating the
brake lever should generate a clear-cut
braking response before the lever touches
the handlebars.
19