Canyon SPeedMax CF Instructions Manual page 18

32 AdjUSTING ThE CANYON SPEEdMAx CF TO ThE RIdER
(I) L-Bend (II) Straight (III) S-Bend
Straight extensions (II) are offered as an ac-
cessory.
These components can also be combined in
other ways to achieve an optimal seating po-
sition. Contact our service hotline at +44 (0)
208 5496001.
The triathlon stem can be set higher by up to
4 cm by installing additional spacers (com-
pared to the stem without spacers). One
spacer is mounted as standard.
A second spacer is part of the standard scope
of supply of the Speedmax CF. Two additional
spacers can be ordered as the TRI Spacer Kit
(accessory).
We most strongly recommend that the mount-
ing of a total of three or four spacers should
be done in our workshop, since all the cables
need to be laid again.
In order to mount or remove spacers, undo the
side clamping bolts of the stem cover and re-
move the cover.
Then undo the four handlebar clamping bolts
and remove them together with the conical in-
serts for the front clamping bolts.
AdjUSTING ThE CANYON SPEEdMAx CF TO ThE RIdER
Remove the handlebars. Undo the three
clamping bolts of the stem and lift the stem
up a little.
Install a maximum of two spacers to achieve
the desired height for the handlebars. You can
have two more spacers mounted in our work-
shop.
Contact our service hotline at +44 (0) 208
5496001.
Ensure that all the spacers are mounted with
the collar upwards and, where applicable,
inserted inside one another, so that the final
result is positive locking to the stem, which is
inserted last of all.
Then insert the relevant M5 clamping bolts:
0 to 1 spacers: in the middle the 20 mm bolt
and outside a 50 mm bolt in each case
2 to 3 spacers: in the middle the 40 mm bolt
and outside a 70 mm bolt in each case
4 spacers: in the middle the 50 mm bolt and
outside an 80 mm bolt in each case
33