Canyon SPeedMax CF Instructions Manual page 20

36 AdjUSTING ThE CANYON SPEEdMAx CF TO ThE RIdER
Ensure the correct use of the bolts and
threaded sleeves of various lengths and that
in each case two connecting rings are insert-
ed between the spacers.
The possible combinations are listed in the
following table.
Spacers M5 screws Threaded sleeve
from above from underneath
0 40 35
5 40 35
10 40 55
15 40 55
20 60 55
25 60 55
30 60 55
35 60 55
40 60 55
45 60 55
Check that the extensions sit correctly in their
clamps. The rubber stoppers with the hole for
the shifter cable should be flush at the rear,
then the extensions are pushed to the rear
until they come up against the stop.
Ensure also that the alignment is correct
when using L-bend or S-bend extensions.
If you wish to replace the standard extensions
with another version, the shift levers must be
removed and installed again afterwards. Note
the corresponding information in the operat-
ing instructions of the gear manufacturer.
AdjUSTING ThE CANYON SPEEdMAx CF TO ThE RIdER
First insert the appropriate threaded sleeve
from below into the hole of the handlebars.
Then insert a connecting ring in each case.
Then insert spacers and connecting rings al-
ternately until you reach the desired height.
Use the narrow red terminating rings between
the top spacer and the armrest.
The extension clamp can also be mounted
underneath the handlebars. do not forget to
insert the connecting rings.
37