Table of Contents
Advertisement
Setting the Auto Exposure Selector Dial (
Using Dual AF35 AutoFlashes
When using dual AF35 AutoFlashes, determine the optimum Auto Exposure
Value for one AF35 Autoflash as described on page 6, then set the same Auto
Exposure Value on the second AF35's selector dial.
AF35 Flash Diffuser
The flash diffuser adds 10° to the angle-of-coverage of the flash. The diffuser
is usually not required unless a wide angle lens is being used. The white
diffuser features two protruding tabs for use in installation and removal. The
tabs on the diffuser should be
positioned away from the flash.
Place the diffuser over the front
of the flash. Spread the two tabs
apart, insert the diffuser into the
recessed front, and then rotate
the diffuser until it locks into
position.
To remove the diffuser, bend
one tab out towards the edge
while lifting simultaneously.
A lanyard can be attached to
the diffuser by threading it
through the two holes.
Holes for Lanyard
continued)
Tab
Push and Lift
to Remove
Tab
7
Advertisement
Table of Contents
