Battery Compartment O-Ring - Ikelite AF35 AutoFlash Instruction Manual

Product Registration
Please take a moment to fill out the online Ikelite Product Registration
form at http://www.ikelite.com/forms/regForm.htm.
Battery Compartment
Opening - Always turn the AutoFlash OFF (as
shown) and dry the flash before opening the battery
door. To access the battery compartment, rotate the
knob counter-clockwise several turns and gently
remove the door. Tilt the back of the flash down while
removing the battery door to eliminate the possibility
of water droplets falling into the battery compartment.
Note: Do not remove the knob from the battery door.

Battery Compartment O-ring

Keep the o-ring and sealing surfaces
clean. Lightly lubricate the exposed
portion of the o-ring with the Ikelite
silicone lubricant provided.
Changing the Batteries
Install four AA-cell batteries: alkaline, NiCad, or NiMH. Refer to the "+" and
"-" markings in the battery compartment to help properly install the batteries.
If the batteries are installed incorrectly it may damage the electronics.
Batteries should be replaced when the flash takes 15 seconds or longer to
recycle.
Closing the Compartment
Check that the o-ring and sealing surfaces are clean, the o-ring is lightly
lubricated and in its original position. Replace the battery door. Make sure it
fits into the recess around the battery compartment. Rotate the knob
clockwise several times and firmly hand-tighten to assure the proper o-ring
seal, otherwise the battery compartment may leak. Caution: Do Not use a
tool when tightening as it may damage the battery door. The o-ring seal is
visible through the battery door. Visually confirm that there is a solid
black line which indicates a seal all the way around the door.
Knob
O-ring Seal appears
as solid black line
when properly
sealed
Mode Switch
AUTO
3