Ikelite AF35 AutoFlash Instruction Manual page 19

Ikelite indoor lighting
Hide thumbs Also See for AF35 AutoFlash:
Table of Contents

Advertisement

Recommendations
- Take the time to examine the entire assembly setup above water. An
improper seal can cause a lot of damage. Always check for leaks once
you place the equipment in the water.
- Photograph through as little water as possible; move in close. Maximum
recommended shooting distance for good lighting is 1.8m (6').
- Use the AF35 diffuser for softer lighting or wider coverage.
- Always carry spare batteries. Weak batteries are the cause of many flash
and camera problems; check the voltage with a meter. Note: it's possible
to buy bad "new" batteries.
- The AF35 has a flexible arm for positioning the flash. Check that the flash
is aimed at the subject being photographed.
- When taking pictures in rapid succession, note that the AF35's flash will
recycle much faster than the camera's built-in flash. Since the camera's
built-in flash is used to trigger the AF35 you must wait for the camera's
built-in flash to recycle.
- Make sure the flash deflector is installed in front of the camera's built-in
flash. This not only helps direct light to the sensor but also aids in
reducing backscatter in photographs.
Ikelite Limited Warranty
Ikelite Substrobes and the AF35 AutoFlash are warranted against any
manufacturing defects for a period of two (2) years from the original date
of purchase. Defective products should be returned prepaid to Ikelite.
Ikelite will, at its discretion, repair or replace such products, and will
return to customer prepaid. All other claims, of any nature, including but
not limited to bulb failure are not covered. Except as mentioned above,
no other warranty expressed or implied, applies to this Ikelite product.
Ikelite Technical Support
Email: ikelite@ikelite.com
Phone 317.923.4523
Fax 317.924.7988
19

Advertisement

Table of Contents
loading

Related Products for Ikelite AF35 AutoFlash

Table of Contents