Table of Contents
Advertisement
Sony Housing Tray Insert Installation
Applies to Single or Dual Tray.
Sony housings have 2 different size Base Plates. The Tray Insert marked
Sony has 2 different cut-outs. To determine the correct cut-out, place each
of the Sony Tray Insert cut-outs against the Sony housing Base Plate as
shown below. Use the cut-out that fits snug around the Base Plate. When
the correct cut-out is determined proceed with the installation.
Base Plate
See page 9 for drawings of the following procedure.
1. The Tray Insert has an adhesive coating on the side opposite the
lettering. Remove the protective backing to expose the adhesive.
2. Align the Tray Insert with the Tray Recess, the arrows on the Tray Insert
should be pointing toward the holes in the tray.
3. Place Insert into Recess and push down to secure Insert to tray.
4. See page 11 for mounting the Tray to the housing.
10
B
SONY
SONY A
Tripod Mount
Tray Insert
Advertisement
Table of Contents
