Troubleshooting - Peak PKC0AX Owner's Manual

TROUBLESHOOTING

Problem Situation
No power Faulty connection Turn the Inverter power switch off, verify cables are tightly
connected to the Inverter and the power source.
output
Battery voltage below Recharge or replace battery.
10 volts
Equipment being Reduce the output load; DO NOT exceed maximum rating
operated draws too for the Inverter.
much power
Inverter in thermal Allow Inverter to cool down. Ensure there is adequate
shutdown condition ventilation around the Inverter. Ensure that load is no more
than its maximum rating for continuous operation.
Low voltage The input voltage at Recharge/replace battery or add additional batteries. Turn on
alarm turns on the input of the Inverter the vehicle when using a 12V DC plug.
immediately needs to be raised
Low voltage Poor battery condition Replace battery.
alarm is on all with low input voltage
the time
Inadequate power or Check condition of battery cables and cable leads. Clean or
voltage drops replace as necessary.
Low power Battery condition may Recharge or replace battery.
output be poor
Faulty connection Make sure the battery and Inverter terminals are clean.
Inverter does The internal protection Contact Old World Industries.
not work after has disabled the Inverter
connecting
the cables in
reverse
Action
12