Troubleshooting - Peak PKC0CF Owner's Manual

TROUBLESHOOTING

Problem
Faulty connection
No power
output
Battery voltage below
10 volts
Equipment being
operated draws too
much power
Inverter in thermal
shutdown condition
The input voltage at
Low voltage
the input of the Inverter
alarm turns on
needs to be raised
immediately
Poor battery condition
Low voltage
with low input voltage
alarm is on all
the time
Inadequate power or
voltage drops
Battery condition may
Low power
be poor
output
Faulty connection
The internal protection
Inverter does
has disabled the Inverter
not work after
connecting
the cables in
reverse
Situation
Turn the Inverter power switch off; verify cables are tightly
connected to the Inverter and the power source.
Recharge or replace battery.
Reduce the output load; DO NOT exceed maximum rating
for the Inverter.
Allow Inverter to cool down. Ensure there is adequate
ventilation around the Inverter. Ensure that load is no more
than its maximum rating for continuous operation.
Recharge/replace battery or add additional batteries. Run the
vehicle engine when using a 12V DC plug.
Replace battery.
Check condition of battery cables and cable leads. Clean or
replace as necessary.
Recharge or replace battery.
Make sure the battery and Inverter terminals are clean.
Contact Old World Industries.
Action