Network Settings - Pppoe Setting - AMX NXA-WAP250G Operation/Reference Manual

System Configuration

Network Settings - PPPoE Setting

Many Internet service providers (ISPs) use the Point-to-Point Protocol over Ethernet (PPPoE) to
automatically assign an IP address to users with a DSL modem. The PPPoE page provides the settings
needed for this service (FIG. 35).
FIG. 35 Network Settings - PPPoE Settings
The items on this page include:
36
DHCP Server/NAT Setting: Enables or disables the DHCP server and NAT on the
WAP250G. (Default: Enabled)
Start/End IP Address: Specifies the start/end IP address of a range that the DHCP server can
assign to DHCP clients. You can specify a single address or an address range.
Gateway: The IP address of the gateway router for the WAP250G, which is used if the
requested destination address is not on the local subnet.
DNS IP Address: The IP address of a Domain Name Server on the network. A DNS maps
numerical IP addresses to domain names and can be used to identify network hosts by familiar
names instead of the IP addresses.
PPPoE Setting: Enables the WAP250G IP address to be assigned automatically from an
Internet service provider (ISP) through an ADSL modem using PPPoE.
Username: If your ISP has provided you with a PPPoE user name, enter it in the
corresponding text box.
Password: If your ISP has provided you with a PPPoE password, enter it in the corresponding
text box.
NXA-WAP250G 802.11b/g Wireless Access Point