Step 4: Wireless Vap #2 Setting - AMX NXA-WAP250G Operation/Reference Manual

Initial Configuration

Step 4: Wireless VAP #2 Setting

The options on this page allow you to set the wireless Service Set Identifier (SSID) and wireless security
encryption key for the VAP#2 wireless network (FIG. 14).
FIG. 14 Setup Wizard - Wireless VAP #2 Setting
Wireless VAP #2 Setting is only available when the Operation Mode is set to AP (see
FIG. 6 on page 13).
Enter the SSID, or wireless network name, which all wireless stations must use to associate
with the NXA-WAP250G. The SSID is case sensitive and can consist of up to 32 alphanumeric
characters (Default: Wireless Network - 2).
Both SSIDs (VAP#1 and VAP#2) must use the same encryption method.
The NXA-WAP250G offers two wireless security options; Wired Equivalent Privacy (WEP) or
Wi-Fi Protected Access Pre-shared Key (WPA-PSK). Select the security you want to use and
enter the appropriate encryption key, or select "None" for no security.
All wireless devices must be configured with the same WEP or WPA-PSK Key values
to communicate with the NXA-WAP250G.
Click Next to proceed.
18
WEP Key — Enter 10 hexadecimal digits (0 to 9 and A to F) or 5 alphanumeric characters for
64 bit keys, 26 hexadecimal digits or 13 alphanumeric characters for 128 bit keys, and 32
hexadecimal digits or 16 alphanumeric characters for 152 bit keys.
WPA-PSK Key — Enter as an easy-to-remember form of letters and numbers. The key must
be from 8 to 63 characters, which can include spaces.
NXA-WAP250G 802.11b/g Wireless Access Point