Wireless Vap Settings - Channel Setting - AMX NXA-WAP250G Operation/Reference Manual

System Configuration
FIG. 28 Wireless VAP 1 Setting - Basic Settings

Wireless VAP Settings - Channel Setting

The WAP250G uses one radio channel in the 2.4 GHz band to communicate with its clients. The radio
channel may be set manually by the user or automatically by the system, which selects the channel with
the least radio interference (FIG. 29).
FIG. 29
Wireless VAP 1 Setting - Channel Setting
If you experience poor performance, you may be encountering interference from
another wireless device. Try changing the channel, as this may eliminate interference
and increase performance. Channels 1, 6, and 11, as the three non-overlapping
channels in the 2.4 GHz band, are preferred. Using channels other than 1, 6, and 11
can cause degraded performance.
30
SSID: The name of the wireless network service provided by the VAP. Clients that want to
connect to the network must set their SSID to the same as that of the VAP interface.
(Defaults: VAP #1 - AMX1, VAP #2 - AMX2; Range = 1-32 characters).
Broadcast SSID: Enable this option to allow the WAP250G to transmit it's SSID at regular
intervals (every few seconds). This feature is intended to allow clients to dynamically discover
and roam between WLANs.
VLAN Id: Enter a unique 12-bit VLAN Id (or VID) for the WAP250G.
Client Access Mode: Select the access mode to be used by the WAP250G (80211g only, or
b+g). By default, the access mode is set to b+g.
NXA-WAP250G 802.11b/g Wireless Access Point