Samsung SCO-2080RH User Manual page 22

Setup

If you press the Function Setup switch in 'AUTO' mode, You can adjust brightness by adjusting
the SENS-UP level. (x2 ~ x512)

Note that the higher the SENS-UP level, the brighter the screen, but the more likely it is that an
after-image will appear.

It is normal for Noise, Spots and Whitish symptoms to appear in SENS-UP mode when the
D-ZOOM level is increased.
WHITE BAL (WHITE BALANCE)
Use the White Balance function to adjust the screen color.
1. When the SETUP menu screen is displayed,
select 'White Bal' by using the Function Setup
switch so that the arrow indicates 'White Bal'.
2. Select a desired mode using the Function
Setup switch.
Select one of the following 5 modes, as
appropriate for your purpose.
ATW : Select this when the color temperature is between 1,700°K and 11,000°K.
OUTDOOR : Select this when the color temperature is between 1,700°K and
11,000°K.(sodium light inclusion) Select this when the color
temperature of environment surrounding the subject is out of the
control range (e.g. clear sky, or sunset).
INDOOR : Select this when the color temperature is between 4,500°K and 8,500°K.
MANUAL : Select this to fi ne-tune White
Balance manually. Set White
Balance fi rst by using the ATW
or AWC mode. After that switch
to MANUAL mode, fi ne-tune the
White Balance and then press
the Function Setup switch.
AWC SET : To fi nd the optimal luminance level for the current environment,
point the camera towards a sheet of white paper and press the
Function Setup switch. If the environment changes, readjust it.

White Balance may not work properly under the following conditions.
➊ When the ambient illumination of the subject is dim.
➋ If the camera is directed towards a fl uorescent light or is installed in a
place where illumination changes dramatically, the White Balance
operation may become unstable.
22_ Setup
MAIN SETUP
1.LENS DC
2.EXPOSURE
3.WHITE BAL ATW
4.SSDR OFF
WB MANUAL
RGAIN 529
BGAIN 532
Press SET to Return