Using Coaxial Communications - Samsung SCO-2080RH User Manual

)

USING COAXIAL COMMUNICATIONS

e.
RS-485 Communication establishment initial value.
Item
Camera ID
Initial value

When making a control system to control the camera, please use to the protocol SAMSUNG-T,
SAMSUNG-E, PELOC-D , PELCO-P, BOSCH, HONEYWELL, VICON, PANASONIC).

When you connecting to RS-485 CONTROL TERMINAL, please peel off the outer skin inside the
RS-485 CONTROL TERMINAL.

In case of SCC-101 connection, change communication mode to 8-E-1 at Communication
confi guration menu. (For more information, refer to SCC-101 manual.)
Coaxial Communications System
OSD Control method
CAMERA
SET
UP
DOWN
LEFT
RIGHT
- Video Cable
The camera's video output port is connected to the monitor with a BNC coaxial
cable, shown below : If the distance between the camera and the monitor exceeds
the recommended maximum, please use an auxiliary video amp.
BAUD RATE
1 9600
DVR
MENU/ENTER
UP KEY
DOWN KEY
LEFT KEY
RIGHT KEY
DVR
ALARM HDD NETWORK BACKUP REC
REC
1 2 3 4
5 6 7 8
ZOOM
9 10 11 12
MODE
13 14 15 16
DVD RECORDER
OPEN/CLOSE
UART MODE
8-NONE-1
CONTROLLER
OSD KEY
JOYSTICK UP
JOYSTICK DOWN
JOYSTICK LEFT
JOYSTICK RIGHT
FREEZE BACKUP SEARCH
TELE WIDE VIEW PRESET
AUDIO ALRAM MENU
USB
RETURN
: BNC
•
• ---- : RS-485
RET PKT
ENABLE
English_17