Importing Ir Hex File Codes - AMX Novara 1000 Series Operation/Reference Manual

AMX NOVARA DCS1000 Device Configuration Software
c.
Then, connect the 12
d.
The
7.
Enter a function name in the Enter Function text field.
8.
Learn the code from the remote controller:
a.
Hold the remote approximately 3-inches away from the
key on the HC to capture the first function. The
soon as the
b.
The [ ] briefly appears in the display to indicate the HC function is captured. Then, 01 appears and the
READY
c.
Hold the HC device approximately 3-inches away from the
same key on the HC device again to verify the
the HC function is captured correctly, a pair of [ ] (brackets) will briefly flash in the display. The
VERIFY LED
message appears in the display, repeat steps 3 and 5. Otherwise, go to step 6.
d.
Press the
program.
e.
Repeat steps C through E to capture all the HC functions on your list.
9.
Click on Capture then press the Send button on the front panel of the IRIS. The function will be added to
the current device library.
Refer to the IREdit instruction manual for information on to storing captured HC functions.

Importing IR HEX File Codes

Alternatively, IR Libraries can be created by importing IR HEX file codes.
AMX does not provide HEX codes, and therefore, cannot give any assurance that
data provided by others is accurate or functional. There are a number of web sites
that make IR HEX codes freely available. One such site is Remote Central, where
you can search for your specific device and look for downloads with "text files with
HEX codes".
1.
In the Edit Options window of the AMX Library Files dialog, click Import Hex File to access the Hex
data import and conversion options (FIG. 53).
FIG. 53 AMX Library Files dialog - Hex data import and conversion options
2.
Enter the name of the function that you want to import, in the Enter Function text field.
62
or 12
VDC VAC
lights and 01 appears in the display.
READY LED
goes off.
READY LED
and s light. The
VERIFY LED
goes off, 01 appears in the display, and the
pushbutton to send the captured HC function to the PC running the IREdit software
SEND
power supply to the 12 connector on the IRIS unit.
VDC
capture window. Press and hold the first
IR
will start blinking. Release the HC key as
SIGNAL LED
will not light if P4 mode is active.
LED
capture window. Press and hold the
IR
function was captured correctly by the IRIS unit. If
IR
pushbutton's
SEND
lights. If an Er
LED
Novara ControlPads & KeyPads