Programming The Attaché
Setting The IR Frequency
The Mio Attaché is set to the IR frequency 38KHz by default. Use the IRMODE Serial Command to change
the frequency to 455KHz. To set the frequency to 455KHz:
1.
Establish a HyperTerminal session with your device.
2.
Send "IRMODE 455" to the device.
3.
Close the HyperTerminal session.
The command, "IRMODE 38" switches the device back to 38KHz.
Persistent Serial Commands
There are a select number of persistent commands the Attaché recognizes. Establish a HyperTerminal session
with your device to use the following commands:
Serial Commands
BATT
@BRT
10
Display Battery Level
Syntax:
"'BATT,#'"
Variables:
# = 0 through 4; 0 turns the display off, 1 - 4 indicates the line of display on the
LCD.
Example:
"'BATT,2'"
Displays the battery level on line 2 of the LCD.
Set Brightness level
Syntax:
"'BRIT-<tag>,<awake brightness level>,<sleep brightness
level>'"
Variables:
brightness level # = a value from 0 - 32.
tag = Red or Blue; affected LCDs
"'@BRT-#'"
(Set LED Awake brightness level)
"'@BRT-#,#'"
(Set LED Awake brightness level, sleep brightness level)
"'@BRT-tag,#'"
(Set Red or Blue LED, brightness level)
"'@BRT-tag,#,#'" (Set Red or Blue LED, awake brightness level, and sleep
brightness)
Example:
(1) "'@BRT-16'"
Sets the awake brightness level to 50%.
(2) "'@BRT-32,5'"
Sets the awake brightness level to 100% and sleep brightness level to
approximately 15%
(3) "'@BRT-RED,32'"
Sets the red LED awake brightness level to 100%.
(4) "'@BRT-BLUE,32,5'"
Sets the Blue LED awake brightness level to 100% and sleep brightness level
to Approximately 15%
Mio Attaché Remote Keypad Device