AMX Novara 1000 Series Operation/Reference Manual page 44

Button Labelling
3.
Install the Key Cap on the pushbutton (FIG. 3):
Key Cap - tilted so that the bottom
of the Cap is placed on the bottom
Press the top of the Key Cap
down to engage both clips at
once, securing the Key Cap
Once the clips are engaged,
the Key Cap is secured
FIG. 3 Placing a Button Label inside a Key Cap
Verify that the vertical orientation of the Button Label is correct relative to the keypad.
a.
Gently press the bottom of the Key Cap (no clip) onto the pushbutton.
Do not allow the clips on either side to engage.
b.
With the bottom of the Key Cap secured, gently press the top of the Key Cap. This action will engage
both clips simultaneously, and the Key Cap will snap into place on the push button.
Be careful to follow these procedures closely - the bottom of the Key Cap must be
installed on the pushbutton before the Key Cap clips engage, or there is a risk of the
button being misaligned.
Also note that removing the Key Caps requires additional steps - see the Removing/
Replacing Button Labels section on page 39 for details.
38
of the pushbutton first
Clip
Pushbutton on keypad
to the pushbutton
to the pushbutton
At this point, do not allow the clips
on the sides of the Key Cap to engage
1
Clip
2
3
Novara ControlPads & KeyPads