AMX Network Lighting Solution ALD-H48 Instruction Manual page 34

Network lighting solution dimmer interface
Hide thumbs Also See for Network Lighting Solution ALD-H48:
Table of Contents

Advertisement

Advanced Programming
Command Interface (Cont.)
Command
?LIGHTSTATE-<index>
PASSTHRU-<buffer>
PROPERTY-<key>,<value>
?PROPERTY-<key>
REINIT
*SETADDRESS-<addr>
28
Description
Query for the state of a dimmer at the specified index.
Responds with LIGHTSTATE-<index>,<state>
<index>: 1..n
Example:
?LIGHTSTATE-1
Send a message directly to the device. The module will not add any
characters to this pass thru string. User must be aware of the exact
H48 protocol in order to use this command.For more information see
Adding Functions to Modules section on page 36.
<buffer>: exact H48 command string
Example:
PASSTHRU-FADEDIM, 100, 1, 2, [1:4:1:1:1]
Sets the IP and Password to be used by the Duet module in order to
establish IP communications with the H48. This method does not
actually set the IP or Password on the actual device. This command
can also set the "friendly name"for the configuration servlet/webpage.
<key>: IP_Address
Password
FriendlyName
<value>: value of the key.
Example:
PROPERTY-IP_Address,10.0.0.5
PROPERTY-Password,jetski
Note: The Duet module uses a default password of "amx01"(without
the quotes). Please change the password property according to your
needs, but DO NOT use a password that contains a "," (comma) in it
or you will not be able to establish an IP connection to the H48.
You must issue a REINIT in order for the new properties to take affect.
Query for the value of a certain key. Replies with PROPERTY-
<key>,<value>.
<key>: IP_Address
Password
Example:
?PROPERTY-IP_Address
Reinitialize H48 IP communications. The communication module will
then query the H48 for the state of all known (found in the component
list. See LIGHTADD- and KEYPADADD- commands.) dimmers and
keypads.
REINIT
Sets the address of the triple-tapped dimmer. The H48 must be in
programming/addressing mode in order for this command to take
affect. Make sure your dimmer is on the correct bus.
<addr>: dimmer address to assign
Example:
SETADDRESS-[1:4:1:1:1]
(case sensitive)
(case sensitive)
(case sensitive)
(case sensitive)
ALD-H48 Lighting Controller

Advertisement

Table of Contents
loading

Table of Contents