Drive Motor Replacement Kit - Henny Penny SCR-6 Technical Manual

2-6. CONTACTOR
(Continued)
Step 7
2-7. DRIVE MOTOR
REPLACEMENT KIT
Step 4
Step 5
1207
6. Check voltage as follows:
Test Points
from terminal 29 to 28
from terminal 27 to 28
from terminal 27 to 29
Replacement:
If contactor proves defective:
7. Remove the four screws securing the contactor to the
bracket and remove contactor .
8. Install new contactor, replace wires, and replace side
panel.
9. Restore power to unit.
1. Remove electrical power to unit.
To avoid electrical shock or property damage, move
the power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove rod and discs from unit. (See Cleaning Section of
the Operator's Manual.)
3. From the control side of the unit, remove the right side
panel.
4. Cut the three wires from the motor .
5. Using 9/16" socket, remove the bolts securing the
motor to the bracket, and pull motor from unit.
SCR-6/8
Results
The voltage
should read the
same at each terminal.
2-5